Skip to main content

Introduction

Last year marked the highest number of human and elephant deaths due to the human-elephant conflict compared to statistics since 2012, the annual report of the Wildlife Conservation Department 2016 indicated.
According to the report tabled in Parliament last week, 279 elephant deaths had been reported in the island last year, while 88 people including 11 females and four children died due to elephant attacks. Compared to 2015, the number of elephant deaths had increased by 74 and the number of human deaths had increased by 25.
Gunfire had been the cause of death of 52 elephants. A total of 47 elephants died due to ‘hakka patas’, 26 due to electrocution, six due to poisoning, 12 due to train accidents and 17 due to other accidents. The cause of death of 54 elephants is unknown while 35 elephants died due to natural causes.
The highest number of elephant attacks on humans was reported in Polonnaruwa, Eastern and Anuradhapura wildlife regions. Seventy eight people were injured due to elephant attacks last year compared to 52 in 2015. In 2016, a total of 1,320 incidents of property damages had been reported due to elephant encroachment.
In addition to distributing Thunder Flare and Serpent Flare, two types of specially designed crackers were distributed to chase away the wild animals. The Department erected 287 km of new electric fences in 2016 in an attempt to mitigate elephant depredations in agricultural and plantation areas.
The department had paid a sum of Rs 8.8 million as compensation for human deaths, Rs. 1 million as compensation for injuries and Rs. 22.2 million as compensation for property damages in 2016. It had also spent Rs. 4.4 million for capture and translocation of 16 elephants.
 
 

Comments

Popular posts from this blog

HL-52S Relay Module

        In our project we have to deal with High Voltage current for elephant fence. In this case we have to use this HL-52S Relay Module. These are few specs of module. 5V, 10A 2-Channel Relay Interface board It can be controlled directly with 3.3V or 5V logic signals from Micro controller. It has 1*4 pin header for connecting power and for controlling the 2 relays marked on PCB as follows. GND - Connect 0V to this pin IN1 - Controls relay 1 IN2 - Controls relay 2 VCC - Connect 5V to this pin. Is used to power the Opto couplers.                 

Radio Frequency Identification Reader

In our project we are using RFID module to sense about incoming elephant threat. Here is brief intrduction about RC522 module. RC522 Specification                   MF RC522 is used in highly integrated 13.56MHz contactless communication card chip to read and write, of NXP for “three” and the application launched a low voltage, low cost, small size, non-contact card chip to read and write, intelligent instruments and portable handheld devices developed better.            The MF RC522 use of advanced modulation and demodulation concept completely integrated in the 13.56MHz all kinds of passive contactless communication methods and protocols. 14443A compatible transponder signal. The digital part handles the the ISO14443A frames and error detection. In addition, support Quick CRYPTO1 encryption algorithm, the term verification MIFARE series. MFRC522 support MIFARE series of high-speed non-contact co...

The Electrical Elephant Fence

An Electrical Elephant Fence is a barrier that use to protect villages from elephant attacks. It produce some serious current and it may harm to the elephants. Because of that elephants can not enter to the villages. But current elephant fence have some problems. Wasting electricity and harmful to other small animals are major problems of those. Sometimes children also get hurt because of that current. So we are came up with some solution for that problem. We are Robust IT introducing automatic electricity supply system for elephant fence. From this system wastage of the electricity to elephant fence will be reduced. This system working with smart elephant collar that we are developing. When a smart collared elephant reaching to the signal range of the elephant fence, system will activate and give electricity to elephant fence. We use RFID (Radio Frequency Identification) tags to track the elephant collar. In the normal situations electricity supply to the elephant fence is off. ...